Buffalo Plaid Sleigh Ride

Project Sheet:
UPC #: 462009012529

Buffalo Plaid Sleigh Ride

Buffalo Plaid Sleigh Ride

Project Sheet:
UPC #: 462009012529

Materials

  • Flat Sleigh with Rope Handle- FJL/37
  • Galvanized Snowflake Ornament- FUZ/1
  • Buffalo Ball Berry Pine Mix
  • Red and Black Buffalo Check Flannel Ribbon
  • Floral Wire
  • Wire Cutter
  • Scissors

Directions

Note: This project is best completed while watching the video.

  1. Use ribbon and wire piece to create bow. Hold end of ribbon and create a loop with 6 inches of ribbon. Scrunch the end of the ribbon and the end of the 6 inch piece between your thumb and finger. Create another 6 inch loop on the opposite side. Scrunch and hold between thumb and fingers. Twist ribbon, then repeat process (twisting each time at the center of bow) to create a bow with 6 loops. After six loops are created, wrap the excess ribbon in a loop and secure it all with a wire. After securing, cut the last loop in half at an angle to create the ribbon tails, DO NOT cut off the excess wire. (Watch video to get a cleared idea of how the bow was created.) Fluff and set aside.
  2. Take the pine pick and bend the stem to the back.
  3. Take snowflake ornament and hang it over the pick. (Placing one piece of jute on each side of the pine pick.
  4. Take the bent piece of the pine pick (with snowflake on it) and hang it on the top rounded piece of the sled.
  5. Take the wire from the bow and wrap it around the top of the pine pick, making sure to wrap in the jute from the ornament and the pick. Twist wires together in the back to secure.
  6. Use extra pieces of wire to secure the decor to the back by folding a piece of wire in half, threading the wire between the slates in the sled, and twisting together on the back of the sled.
  7. Display and enjoy!