SOME ITEMS IN THIS PROJECT ARE NO LONGER AVAILABLE

Let it Shine Frame

Project Sheet: cd2917
UPC #: 420004018922

Let it Shine Frame

Let it Shine Frame

Project Sheet: cd2917
UPC #: 420004018922

Materials

  • Wood Tile Board w/ 9 Tiles
  • Acrylic Paint (Thicket, Pure Gold Metallic) - FolkArt
  • Vinyl (Let Your Light Shine) - Decorating  Your Life
  • Paper (Fireflies in the Garden) - One Canoe Two
  • Moon Lights (Warm White) - Darice
  • Bristle Brush
  • Foam Tape - 3L
  • Paper Trimmer
  • Craft Knife
  • Scissors

Directions

  1. Remove tiles from frame discard or use for another project.
  2. Paint the entire wood tile board frame Thicket, apply a second coat if needing letting dry between coats.
  3. Dry brush wood frame, using very little Pure Gold paint.
  4. Make sure hanger on backside is at top. Use craft knife to cut a little slot in a bottom corner to thread the lights through from backside.
  5. Apply Foam Tape all the way around the inside outer edges of frame.
  6. Trim paper as needed to fit into the frame. Apply vinyl to the center toward the top, following instructions on vinyl packaging.
  7. Thread lights through the slot in wood frame, attach the lights to the backside of the Firefly paper using pieces of foam tape.
  8. Place paper into the frame, pressing it around the edges to adhere to foam tape from step 5.
  9. Using Foam Tape, secure battery pack on backside of frame, so the on/off switch faces is against the edge to turn it on/off easily.
  10. Display.