Christmas Tree Delivery Sign

Project Sheet: CD2565
UPC #: 420004017710

Christmas Tree Delivery Sign

Christmas Tree Delivery Sign

Project Sheet: CD2565
UPC #: 420004017710

Materials

  • Rectangle Hanging Plaque - CAL/63
  • Vinyl (Farm Fresh Christmas Trees) - Decorating Your Life
  • Doodlebug: Here Comes Santa Collection
    • Paper (Tree Lot, Ladybug Gingham/Linen, Ladybug Swiss Dot)
    • Die Cuts
  • Acrylic Paint (Titanium White) - FolkArt
  • Jute 2ply
  • Adhesive Foam Squares
  • Greenery Black Spruce Pick
  • Mod Podge
  • Glue Gun/Sticks
  • Paper Trimmer
  • Craft Knife/Scissors
  • Pencil
  • Foam Brush
  • Photo (optional)

Directions

  1. Remove the 6 metal rings, set them off to side until later.
  2. Paint all wood edges Titanium white. Let Dry.
  3. Measure and cut Tree Lot paper, making sure the trees are up right, 10-3/4" x 4-3/4".
  4. Using the remainder of the Tree Lot paper reverse side, cut two strips 1-1/4" x 4-3/4", make sure the paper is facing upright.
  5. Lay out paper on sign, see picture for reference. Mark the holes at bottom, using small paper hole punch or scissors,punch holes in paper where markings are.
  6. Apply Mod Podge to sign and place paper on top and smooth out making sure holes line up. Adhere the two strips that go on the outside edges of sign, using Mod Podge and let dry.
  7. Trace three smaller square wood pieces, two squares on Ladybug Gingham/Linen and one square on Ladybug Swiss dot.
  8. Line the paper up on each square and mark the holes and using small paper hole punch or scissors cut holes where markings are.
  9. Apply a layer of Mod Podge on the wood squares, place paper on each square lining up the holes, smooth out and let dry.
  10. Apply vinyl to the top portion of the sign, following instructions on package.
  11. In with the vinyl there is a small green Christmas tree, apply that to the small square with red dots.Make sure the holes are at top, tree facing upright. Optional: attach photo to this square instead of applying the vinyl tree.
  12. Pick the two Santa delivering Christmas Trees that are facing opposite directions. Use foam squares to attach to the two remaining wood squares.
  13. Clip off small amount from greenery pick attach using hot glue.
  14. Cut three strands of of Jute, about 28 to 30 inches long. Tie knot in center of jute ( all 3 strands) tie another knot on each side of center knot ( about 4 inches from center) Now thread the ends through the hanging hooks, tie knots
  15. Replace the metal rings and display.